Picture this: it’s dinnertime and you’re ready to whip up a delicious meal for your family. You turn on your stove, but one of the burners won’t ignite. You turn the knob again, and still, nothing happens. Frustration sets in, and you start to wonder what could be causing this pesky problem. Don’t throw in the towel just yet, because we’ve got you covered.
Possible Reasons Why Your Range Burner Won’t Ignite
There are a variety of reasons why your range burner won’t light. One common cause is a clogged igniter, or the igniter has gotten wet. Other common causes include loose connections, faulty parts, and more. These are just a few of the potential culprits when it comes to non-igniting range burners, but don’t worry – we’ll help you troubleshoot each one.
Range Burner Won’t Ignite Due to a Clogged Igniter
If your range burner won’t ignite, one of the most common causes is a clogged igniter. The igniters can get clogged with food debris, and over time can become blocked and unable to create the spark it needs to light the burner.
How to Clean an Igniter
To clean an igniter, start by removing the burner grates and caps. Next, use a wire brush to gently clean the debris off the igniter. Once it’s cleaned, be sure to reattach the burner caps.
Wet Burner Caps or Igniters
Are you having trouble igniting your burners after cleaning or spills? Moisture can often get trapped in the burner heads, causing issues, including a range that clicks but doesn’t light.
How to Remove Moisture from Range
To fix this, clean the burner heads and caps, shake out any excess water, and allow them to dry completely. Make sure the burners are in the right position, and that the burner heads and caps match and fit properly. Afterward, plug the unit back in and try igniting the burner with about ten clicks.
Loose Connections
Loose connections can also be the culprit behind why your range burner won’t ignite. When the connections aren’t secure, they can’t produce the spark needed to ignite the gas. As a result, the burners won’t light up.
How to Tighten Loose Connections
To fix loose connections, unplug the stove and remove the burner caps. Then, using a screwdriver, tighten all of the connections. However, be cautious not to over-tighten them and cause damage. After tightening the connections, reattach the burner caps and plug the stove back in. Finally, try turning on the burners to see if they light up. Any further repair attempts should be done by a professional.
Faulty Parts
If your range burner still won’t ignite after following the previous troubleshooting steps, there may be an issue with a worn or faulty part, which should be diagnosed and replaced by a range repair technician.
For range repair, you can depend on, contact the range repair experts at Atomic Appliance Repair. We look forward to serving you!
